Aluminatus Corner Clamps With Height Adjuster & 1mm taller clamps

This is a remix of GKbeers bed corners and clamps.
I added two holes so you can add a 5mm x .8 pitch adjuster bolt on the outer corner or on the inside. My heater plate is a bit smaller than my glass, so I chose to use the inside hole. This adjuster bolt will require you to drill a hole at each corner. The hole size in the corner is such that the bolt can thread in tightly and require no further hardware to stay snug.

The F-300 parts are the fixed pieces that get attached and tightened on the rear and along one side. These remain stationary.

The A-300 are put on the front and the other side and are snugged down lightly once your glass or print surface is level.

I added 1mm to the height on the part that contacts the glass. My glass has a rounded edge and the extra height was needed for better grab.

I also added a tiny angle to the face of the clamping part to help if you have rounded glass edges. It will be fine for flat edge print plates also.

I increased the text size on the clamping parts for better readability.

(8) M3 x 16mm .5 pitch screws and hex nuts are needed to complete a full set of corners.