Summary

This is a USB (or anything tiny) box with lid that I created to use when I give out USB sticks to my clients.

Instructions

Hello everyone - welcome to my first Thingiverse design. I hope you enjoy it.

Instructions (Read Carefully if you use an M3D Printer):
I used an M3D printer with Cura slicer to print this part on a Mac. It is a bit too big to stand up long ways for an M3D (you will crash), so I recommend using support for the over hang lips. Also, use a raft or brim (I used a raft) to prevent any of the corners to lift. Over all, the lid slides smoothly, however please note there is no locking the lid in this design. Maybe in future designs, I will make that change.

Infill: 20%
Bottom/Top Thickness: .6
Shell Thickness: .7
Material: PLA (MakerBot Cool Silver)
Temp: 215c
Print Speed: 40mm/s (My M3D doesn't like to move too fast)

(Important Side Note: If you have a 3D printer bigger in height than an M3D, then standing it up can give you a better lip without cleaning out the support. For an M3D, however, you will crash at the top when it tries to go home after it prints.)

Safe Printing everyone! :P

Enjoy.

USB box with lid