Summary

I mounted my new Ikea kitchen a few centimeters higher than originally intended.
I designed this part as an extension that can extend the range of the Metod systems furniture leg 1-2 centimeters, so i could replace the old magazines and books used as spacer. ;)

Print Settings

Printer:

CTC (FlashForge Clone)

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.3 mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I haven't tested them yet, depending on the load it might be good idea to increase infill or print solid.</p><p>Since i had some problems with the layer adhesion of the ABS print, i tossed the part in ABS slurry (Acetone &amp; ABS mix) to increase the outer layer stability.</p></div>

Ikea Metod Leg Extension