ZMR250 Quadrocopter Landing Gear

Landing Gear for a 250 Racing Quadcopter like ZMR 250, QAV 250 or other, simply use a screw to mount them under each arm. It will lift the quadcopter a little bit off the ground and keeps most of the mud away from the bottom-plate. They are shorter than the normal legs that come with an ZMR250 and will pop off in a hard crash. Any 2.5 to 3 mm screw with a lenght at least 5mm plus the thickness of the arm will fit. It weights less than 4g printed with PLA. No support, no raft, 2 shells, no fill used and 0.2mm layer height. This is something you loose once in a while, so PLA is your eco-friendly choice.

V3.2: Stronger Sphere, older Version was a bit thin for rough flying...