OMT² - Hex Bed Leveling Tool (2.5mm - 1/10")
Specs :
1/4"(6.35mm) Hex compatible
To use with a M3 (1/10") Allen key
Description :
This tool was, at first, created to level the hot bed of the FABtotum, which uses M3 screws.
If you need to know "precisely" by how much of an angle you've turned that M3 (2.5mm - 1/10") screw, this tool is for you ;)
This is just a tool head. If you need a handle or other tools for your bit holder,
visit : http://www.thingiverse.com/thing:1381028
This tool comes in 3 flavours :
- Tight
- Basic
- Loose
To know which one to pick, simply print this quick test :
Instructions to make :
- You may need to clean the hole by passing the Allen key a few times through it
- Some filing/sanding may be needed to ensure a perfect fit with the handle
Instructions to use :
- Put the tool in the screw head
- Place yourself facing the 0 section of the tool
- Turn the screw until you face the the angle you wish to reach (in the right direction, use the arrows)
- That's it ... ^^
The photos show an early prototype, new photos will be available shortly