Grasshopper Quadcopter v1

All original design based loosely on a grasshopper and specifically for my set of components. This is a work in progress.

• 4/5/16 - Updated batterybox and batteryboxtop for
  improved fitment. Also adjusted power plug
  to fit XT90 female plug in batterybox.

• My list of equipment that fits in the design:
  NAZA LITE Flight Controller -location: TopShell
  Andoer Folding GPS Antenna - location: TopShell
  LED control board (36x36mm) - location: TopShell
  Andoer Power Distribution Board - location: BoomBody
  RioRand Camera Gimbal - location: BottomShell (Gopro 4 Session attached)
  DJI E310 Motor Kit (ESCs) - location: BatteryBox
  Multistar 4S 8000mAh battery - location: BatteryBox
  Futaba R2008SB receiver - location: BatteryBoxTop
  DJI E310 Motors - location: EngineMounts (duh).
  Large LED Lights (red & green) - location: ledmounts (duh again)

Also needed: 2x300mm 12mm diameter carbon fiber tube (back motors)
2x135mm 12mm diameter carbon fiber tube (front motors)
2x200mm 10mm diameter carbon fiber tube (front legs)
1x80mm 10mm diameter carbon fiber tube (back leg) (length guestimate)