Summary

A wire holder array that can hold 6 small and 4 bigger wires in order. You can use some blu-tack to hold it firmly against the surface.

Note: Flexible PLA is needed for the "gates" on top.

Print Settings

Printer Brand:

Ultimaker

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p><a rel="nofollow" href="https://ultimaker.com/" target="_blank">Ultimaker Original</a></p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>This is printed in two phases. The array itself can be printed quite normally. After that, a long, thin stripe of flexible PLA is needed. It'll be glued on top of the array and then cut over each wire hole. This way the wires will stay in place.</p><p>For the flexible PLA this kind of settings was found to work: "10mm/sec; .2mm layer; 240C;" (see <a rel="nofollow" href="https://ultimaker.com/en/community/11522-flexible-pla-questions">https://ultimaker.com/en/community/11522-flexible-pla-questions</a>)</p></div>

Multi-wire holder