Summary

A door chock design I remixed from schlem's original door chock design.

Here is schlem's original design:
http://www.thingiverse.com/thing:93859

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/5EoTQBYERzD

If you have any design ideas or suggestions, I'd love to hear them so I can refine this.

Print Settings

Printer Brand:

RepRap

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Monoprice Maker Select</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.2mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>At least 40%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>You will need to rotate it so it's upside down, having the large notch facing upward, that way you don't have to print with supports</p><p>Infill you don't need to ramp up super high, I keep mine low to save on filament.</p><p>114mm Long x 38mm high x 30mm wide if you print it at 100% scale</p></div>

How I Designed This

So I've wanted to make a custom door chock of my own for a while and I found a few designs on Thingiverse that I wasn't 100% pleased with.

So I decided to make my own, and add a few features I'd have liked.

I took the original design, and used the Square Hole tool on Tinkercad to create the holes I wanted. Basically just rotating the square and sizing it where I wanted it, and it came out rather good in my opinion.

It's designed so you can use it as both a door chock, and if you inside it sideways, and turn it, it can also be used in the door jamb itself.

The chunk cut out near the bottom of the chock is so you can put it on your helmet if you'd like, it's designed to have the strap go in there. I'm hoping the cut isn't too deep making it difficult to remove.

I have also included versions with and without holes, and with and without the notch for the helmet strap.

The hole is 6mm large so you can fit most kinds of rope or a ziptie or whatever your fancy is.

Firefighter Door Chock V1