Cardan Joint Effector Mount for Rostock Max v2

This is a bracket that slips over top of one of the tabs on the SeeMeCNC Rostock Max v2 effector and adds a Cardan Joint for a flexible tube. You could blow air or in this case I am experimenting with adding a spot light to highlight the print surface for an HD camera. Not sure if this is too much mass hanging off one side or not but we shall find out.

I have also published a model of the effector tab itself I used to make this mount. This is useful if you want to make something to hang off this tab. There are three of these tabs on the effector at 120 degree angles. You just turn the model into a hole in TinkerCAD and slide it into your part or mounting bracket.
http://www.thingiverse.com/thing:1691695

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/hR1yfC38Njf