Summary

This is a box to house a DROK variable USB load device. Not fancy, but functional. I purchased the device on Amazon. https://www.amazon.com/gp/product/B016EYMVX4

Print Settings

Printer:

QiDi

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>I used 0.2 / layer with MG PLA</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>Doesn't matter</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I used 5 top, 5 bottom, and 5 outside layers.  As the walls are only 1mm thick that will just about fill the bill.</p></div>

Post-Printing

This was a quick and dirty design job

            <div><p>If I had taken the time to do an angled roof section rather than a 90 degree roof next to the fan I think this object would have printed with no supports.  That would have saved a lot of time spent on the post print removal of the interior supports.  If I ever need another one I will do it.</p><p>So, remove the supports, pop off the two knobs, angle the device into the enclosure, and pop the knobs back on.   I did not do anything to tie this thing into the box as its a close fit.  I did add a small piece of double-sided mastic (foam tape) under the device's USB tang to hold the bottom onto that area.</p></div>

Custom Section

If you want to tweak, have fun...

            <div><p>This thing was made with Tinkercad. Edit it online <a rel="nofollow" href="https://www.tinkercad.com/things/b0Z1aXg4Wy0">https://www.tinkercad.com/things/b0Z1aXg4Wy0</a></p></div>

Drok Adjustable USB Load Case