Raspberry Pi 3 Snap Case Vented

Snap case for Raspberry Pi 3 (and probably 2). Separate files for each half are uploaded separately.

Includes hole for reset switch. Reset switch is Radio Shack 275-1547 momentary contact. I trimmed the lugs on the switch to allow it to be soldered directly into RUN holes on PI board. This is especially useful for RetroPie configurations. You can fill the hole in if you don't need it.

It worked at 200 microns. Smaller layers might have resulted in a more accurate fit.

Photos are before a few minor tweaks. Added better access to the SD card and made switch hole smaller. Also added more clearance for snaps to help them seat without trimming.

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/kthDENxuOlH