Lawnmower_pull_handle_Ergonomic_halved

I cut the handle in half, found that the round portion no matter what I did (brim or raft) would come off the bed before the large handle portion had a chance to build plastic between the handle and the neck...cut in half, can now print both halves with the flat portion directly against the bed which will give maximum adhesion, then simply glue the two halves together (if using ABS, just use some ABS juice and voila!
This really is a nice handle..but not very bed friendly

Updated: 7/28/2018 per request, added 2 indexing holes and a pin, print 2 pins...glue in holes, glue together, should assist in keeping it square enough for government purposes