Summary

This is a shuttle for hand-weaving or lap-loops. This was a request from my mother, who wanted a shuttle a little smaller than the one that came with her loom.

I have also created a curved version.

Print Settings

Printer:

M3D Micro

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>This is a replacement for what would normally be an injection-moulded part. It's only a few millimetres thick, and it needs to stand up to a fair bit of handling. I recommend printing it solid (100% infill).</p><p>If you have problems with the ends of the shuttle curling off the print bed during the print, open the "printing-assistance" section of the Customizer and set Pad Height to a value equal to twice your layer height. For example, if you are printing with 0.2 mm layers, set Pad Height to 0.4. This adds pads to the ends of the shuttle. The wide pads should adhere well to the print bed, keeping the model flat during printing. When the print is complete, simply snap them off by bending them back and forth until they break.</p></div>

Customizable Hand-Weaving Straight Shuttle