Sous Vide / Emersion Circulator

Sous Vide / Emersion Circulator

• Design is for a 45mmx45mm PID
• Temperature probe mounting hole is 8mm
• Side inlet for power cord
• Front mounted rocker switch
• Heater coil cage protects objects from touching the coils

**Updated : New coil cage because during printing the thin walls not being connected started to wobble when the nozzle would extrude more plastic causing surface imperfections.

**Updated (1/14/17) : Added Mounting bracket

**Updated (1/21/17) : Added mounting for temperature sensor because the sensor being inside the heating coil cage was giving relative measurements to the preheated water.

**Updated (1/25/17) : Added an intake funnel to help create a convection current by pulling the heated water down and dispersing it. (Support is needed for this) It is designed for a Rio+ 200 Submersible Pump.

• All files (.STL and .SLDPRT) Included