Summary

This is, essentially, the same as the HC-SR04 Ultrasonic Rangefinder Mounting Bracket by Matter153. I widened the connector cut-out to account for 5-pin design of the HY-SRF05 sensor (as opposed to the four pins of the HC-SR04 sensor).

Obviously, Matter153 did all the real design work here and I just made a minor tweak. If you want to send a tip, please send it to Matter153.

Print Settings

Printer:

Prusa i3 MK2

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.200mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20% Cubic</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Printer is a Prusa i3 MK2. </p><p>Printed in PLA or PETG, it can be printed as is. Printed in ABS, scale it up slightly (I used 101%) to account for shrinkage. I prefer to print this in PETG as it is more flexible and makes it easier to pop the sensors into (and out of) the brackets.</p></div>

Post-Printing

Mount with #6-32 screws.

Matter153 says "If you cut a piece of a foam paper plate to put behind the sensor it helps considerably with vibration if you are using this with a robot." I haven't done this myself, but it sounds like good advice so I am passing it along.

HY-SRF05 Ultrasonic Range Finder Mounting Bracket