Box with sliding lid designed to fit into even the narrow rooms of Ticket to Ride. Comes in several types and with several types of lids.

BOX

Outer dimensions: 10 cm deep, 7 cm wide, 4 cm tall (rounded outer corners by 4mm).
Inner dimensions: 9,7cm x 6,7cm x 3,6xm (rounded inner corners by 4mm).
Access dimensions (top of box): 9,4 x 6,4cm (rounds in at the top to ensure lid is secure)
Walls are 1,5mm which I have found to feel solid while not needing 'infill'.

The box is designed to fit into all rooms of Ticket to Ride (yes, it is smaller than the rooms and may slide around).
Will fit most size cards as well. Need to store a few cards along with some tokens (like for Game of Thrones) - use the 'gap' version to allow room for the cards on top, while keeping things separated underneath.

Recommendation: Print the boxes in a neutral color and just use different colors for the lids (or make the boxes and lids match).

Box types

• 1 room: no separators
• 2 rooms: one center separator
• 2 rooms, 5mm gap : one center separator, ending 5 mm before the top (to allow larger items on top, like cards)
• 2 rooms, 10mm wall : one center separator, ending 10 mm from the bottom (to allow larger items on top, like cards)
• Ticket to Ride (Ttr) Europe: separator near the back to keep stations separate from the trains

LID

Dimensions: 9,85 cm deep, 6,75cm wide, 0,13 cm tall (rounded corners by 4 mm)
At a thickness of 1,3mm the lid feels robust without being a waste of filament and still slightly flexible.
Oriented the same way as the boxes, such that any 'odd behaviour' your printer has will happen the same place on both box and lid to ensure they have the best chance of fitting together.

Slides into the top of the box.

Recommendation: Print in different colors for easy identification of the content.

Lid types

• Plain: No grooves or holes to help slide it back out (perfect for customizing)
• Back Groove: A groove towards the back of the box
• Center Hole: A 2cm hole in the center of the lid allowing an easy way to get the lid on and off the box.
• Front Tap: A raised edge at the front of the box, no higher than the edges keeping the lid down.
• Card Stand: Ten rails lightly titled, used to keep cards sorted/visible without holding them in your hand

SEPARATOR - DO NOT PRINT

If printed, this will NOT fit in the box!
Separator is included for completeness in case someone wants a box split into custom sizes:

• Download the 1 room box and the separator
• Use your favorit 3D design program to combine them to your hearts content =0)