Summary

The Key Topper by DrPeper https://www.thingiverse.com/thing:1736435
was just a little to long, so the key would not go all the way into the lock and would not allow the key to turn. I trimmed a little bit off the end and rounded the edges again.

Print Settings

Printer:

ANET A8

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.08</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I had to print this at 103% scale to fit my key without forcing and bending the print.  A few drops of supper glue keeps everything together after dry fitting.</p><p>Printed on bare glass that was cleaned with alcohol.  This gives a shinny glass like finish to the sides of the print that touches the glass</p></div>

Key Topper Trimmed