Summary

I lost the battery cover to my Fluke wand years ago and I decided I would attempt to design a new one from scratch. I borrowed the cover from a coworkers wand and measured it as best I could. I used MS 3D builder.

Print Settings

Printer:

XYZ Da Vinci 1.0 AIO

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>High</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>30%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>You'll likely need to file/cut some pieces as I needed to make the two notches larger than the original one I used as a guide due to the fact our printer made the first version's notches too small. Pro tip: don't remove the support from the spring lock. I curved mine with some tweezers so create a slight spring that keeps the spring lock in place. </p><p>I used PLA filament but ABS would work just fine. </p></div>

Post-Printing

Fluke IntelliTone Pro 200 Battery Cover