Towelhanger for glue on the wall

Tried some of the designs found on www.thingiverse.com but as most of them was not good designs and the one I liked has a error in the design so it prints a spacing in the layer for the hock, making the hock break of but the foot stay on the wall. So I got tired looking for finish made design and made my own.

This can hold 3 towels at same time, one on each nob and one in the crack of the 2 nobs.

Make sure u glue it good to the wall and do a stress test on it before glue it.

I used 45% infill because my towels are large.

Depending on how you turn the model, you might not need support.

The original Solid Edge PAR file follows, as well the STL file.

Update! Both the PAR and the STL size is to small so a scale of 200 present will do good. However, scaling will increase the crack of the 2 nobs so you might need to edit the PAR file and I recommend a spacing of only 1mm, then save it as STL and then scale it by 200%, this will make the crack distance perfect. Also I found that having it standing while printing makes best result.