Two Part Bugatti Veyron Pinewood Derby

This was a difficult model to print. The resolution of my printer or the Cura slicer that I used would not let me print the windows well. There were some holes in the body as well. I think it would have printed better as a solid. The sectioned models were not working for me so I put it in TinkerCAD to cut the car in half. I had to remove a random structure that was on the inside of the car where the block should go. I think it was an error in the file. I added structure behind the side windows in hopes of supporting them. While I was printing the support structure for the rear part failed. Luckily I was near by and I was able to stand it back up while I paused the print. It lined up fairly well but I had to use some JB Weld to fill in a gap after printing. Ultimately though it was still a cool print.