Z-AxisMotorMount

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/g7pKpK5ssyI

This is a re-mix of the thing:2204847 by arunasv. The major difference is that it is intended to mount the long surface to the Z-frame with two screws to mount to the Z-Axis Motor. The intent is to provid lateral support for the motor so that the mass of the gantry, extruder, and hot end do not cause the motor to rotate out of alignment. In tinkercad I eliminated the span to the far side of the z-axis motor, and added a 2mm layer along the Z-axis to provide that support.

There are other ways of doing this, including using the original part, adding support up the z-axis that gets secured higher, however I was looking to be able to lift the motor to get a little bit of extra Z height, and if you go much taller than the part uploaded by arunasv, you start running into the Z-axis range of motion.