Robo 3D Adjustable Z Axis Support and Stabilizer

These Z Axis supports for left and right rods can be adjusted to suit the precise dimensions of your Robo 3D.

• Brackets fit to the case using 1" double sided foam or mounting tape. Fit the brackets loosely first and mark with a pencil where each bracket needs to stick. Make sure the bracket tab is on top so it is easier to remove the case later.

• Pinch block uses M3 screw, adjustment tab uses M4.

Before tightening up the M4 nuts make sure the X Axis carriage moves freely up and down the Z Axis.