water holder for Janoel 12 Incubator

This container holds water to increase the humidity in the Janoel 12 incubator by about 15-20%. There are holes in the bottom of the divider allowing water to flow freely between the sides. With the lid on one side, the container only needs to be refilled every other day.

Just adding water to the bottom of the incubator raised my humidity too much, so I wanted a smaller container that would hold water and only have to be refilled every other day.

Instructions: Fill the container with warm water. Put the lid on the side of your choice. This container will fit on the top tray between the egg turning tray and the wall (on the side by the thermometer). If you print the container out in clear filament, you should be able to see the water level through the side of the incubator. I added a small piece of craft foam to float on the closed size so the water level was obvious.

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/llHfrJycAiQ