Summary

An upright bass with a stand to give as gift to musicians.

Instructions

Printed these with ABS 3mm using a .35mm nozzle.

The bass was printed with 50mm/s and 25% infill, but its possible to put less infill and make it faster.

The stand was printed with 65mm/s and 5% infill. It has 9.5cm of height, which was as high as my printer would go, so be sure to scale as needed.
Also the stand was printed 5% larger than the actual size, so that the bass would fit nicely in it.
You can put the name of the person you want to give this to on the stand, just like I did.

It may be better if you make your own adjustments to the strings since it was really difficult to print these without falling apart.

All pieces that are printed apart were glued with acetone.

Upright Bass