Keychain Phone Stand

Keychain Phone Stand Remix. I just changed the design a bit. The original design is cool and so minimalist, because this stand is basically 2 small flat pieces that hangs on your key ring, and clicks together when you need it.

Few notes:

• There are 2 versions of the .stl file. 1 that is less slanted (holds your phone almost upright), and 1 that is more slanted back. Since there are so many types of phones and phone cases out there, you'll just have to see which works for you.

• Takes about ~20 min. to print, and uses less than 1m filament.

• You'll most likely have to sand the "male" piece just a tiny bit to get these to click together. Don't get all crazy, it only takes very little sanding before they click together. Obviously, you don't want them loose.

Have fun!