Forbidden Island Field Tile

I so enjoyed the explanation provided by drathbun for his remix of this piece, that I chose to honor it by remixing it too.

This is a Remix Inception (mix of a mix of a mix). I started here:

https://www.thingiverse.com/thing:3137415

drathbun had reworked a tile holder for Forbidden Island by and proceeded to explain the removal of excess parts in order to speed up printing and conserve filament. It printed wonderfully for me on the first go and I thought I could expound on the process and came up with this remix.

I opened the thingy into SketchUp and noticed that there was a lot of merging problems. After about an hour of cleaning up the lines and then another hour moving the ribs around, I was able to create this fun minimalist piece. I can not vouch for its integrity in a drop or abuse, but I was able to sheer off some weight.

I am able to print the four at a time .stl. However, I know not everyone can so, I included the single.

With the settings that I have set to Cura factory settings for Low Quality- 0.15mm, these are the end results.

ku4tp
Time: 1h 20m
Time x4: 5h 23m
Length: 4.02m
Length x4: 16.10m
Weight: ~11g
Weight x4: ~48g

WardF
Time: 1h 20m
Time x4: 5h 23m
Length: 4.01m
Length x4: 16.08m
Weight: ~11g
Weight x4: ~47g

drathbun
Time: 1h 0m
Time x4: 4h 5m
Length: 3.12m
Length x4: 12.49m
Weight: ~9g
Weight x4: ~37g

Dport406
Time: 48m
Time x4: 3h 13m
Length: 2.34m
Length x4: 9.30m
Weight: ~6g
Weight x4: ~28g

This is my first contribution to the Thingiverse community. Happy printing!