Talon Claw SMG AR15 - A short Caliburn
Just the files that are different than a non-takedown Talon Claw. Same hardware etc.
The front cover is a long print. To get the detail in the PLA I used a .2 print and went slow since it is tall, took 22 hours to print. Just an FYI. You can use any of the rear butts, pistons, sliding shoulder stock, fixed shoulder stock in my other files.
I think a TC without a cover works best in game play since it is easier for me to grab the regular grip. But if you dont mind the AFG grip this does look nice.
I tried to model this after an AR15 I found on the web. Well close to one.
I would not build this as your first Caliburn or TC. Build the regular version.
The front cover has no print to print prime contact, use nylon thread covers.
EDIT, this is the stock I know the rear extension tube fits. Printed both at .2mm. Very snug.