Summary

4th Generation E3D v6 mount for Lulzbot TAZ 3.0+
No modification of original parts.

Instructions

Print one of each part. Install M3 heat inserts.
Bolt together w/o the hotend and clean up the opening. Remove any little fluff that will keep the mount from fully closing around the hotend.
add clamp around hotend and tighten until both halves are flush. Be careful not to force it as the part may split. It a snug fit but if the opening is clean it will snug up with no problem.
If your going to use this with the wade extruder. Insert a short piece of PTFE tube ( came with the hotend) and trim it off flush with the top of the mount. Use a drill bit to make a small cone in the end of the tube.
Adjust your z endstop. and enjoy.

EZ E3Dv6 Drop-in Replacement for BudaSchnozzle v2.0 on Lulzbot TAZ