Summary

This is part that gets hit when doors are swung open.

Similar to this thing https://www.thingiverse.com/thing:2792015
which I would have just used had I search first :)

This one should be stronger when printed in three pieces and assembled. The other thing - printed in one piece - will have stresses either in tension of layers around screw or shear on the pin part.

Print Settings

Printer Brand:

Printrbot

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Printrbot Plus</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>90%</p></div></p>                                                    <strong>Filament:</strong> any PLA                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>PETG/ABS/Nylon would be better...rnrnPLA part has not failed yet.</p></div>

Post-Printing

Assembly

            <div><p>Print two pin parts and join.  Then slide pin into hole of other part and join.  Make sure you get direction of pin correct.rnrnI used Weld On Acrylic 4 solvent.  CA glue probably also good.</p></div>

Ikea Hemnes shoe cabinet compartment door stop