18650 Solderless battery holder

简介：免焊接18650电池盒，包括一节和两节的。
原理：利用3D部件的轻微弹力紧固电池。
打印：螺纹处的打印层高不能大于0.2mm，已经计算了公差，如有不吻合，请根据打印机情况适当缩放。
1.打印完成后，导线穿过底部电池盖后留取适当长度，打一个结，导线头部剥除一定长度，使用3x4mm-3x6mm螺丝固定在弹性元件上，弹性元件放入底部电池盖。
2.电池盖旋入电池筒。
3.头部电池盖过孔穿入导线，留取一定长度后打结，导线头剥皮，使用3x4mm-3x6mm螺丝固定。
4.放入电池，旋入头部电池盖即可。

Just from Google Translate:Introduction: The solderless 18650 battery case includes one and two sections.
Principle: Fasten the battery with a slight spring force on the 3D part.
Printing: The print layer height at the thread cannot be greater than 0.2mm. The tolerance has been calculated. If there is any mismatch, please scale it according to the printer.

1. After the printing is completed, the wire passes through the bottom battery cover and then takes the appropriate length. A knot is made and the wire head is stripped to a certain length. The wire is fixed on the elastic member using a 3x4mm-3x6mm screw, and the elastic component is placed in the bottom battery cover.
2. The battery cover is screwed into the battery can.
   3.the head battery cover through the hole through the wire, after a certain length to tie, tie the wire head, use 3x4mm-3x6mm screws to fix.
   4.put the battery, screw into the head battery cover.