Garmin GPSMAP RAM mount bike steer holder

use support, rotate for best 3D print, i used 95% infill, 8 walls, 8 bot, 8 top, 0.2mm and a bit over heat to make it as strong as possible..

M5 strews,
designed to fit the thick part in the centre, and hight hand usage
due to the offset, the fixture is turnable, so you can also put it left side, and offset for left side if needed, it is symetric.
check steer is 25.6mm diameter, or simply scale it slightly, the holes in the RAM mount
will let you scale +/- 5% and still fit just fine.
I put a little bit contact glue on the steer before mounting it, so it is not going anywhere,
all is very thick and strong made for most rugged possible construction.