Dragon's Tower for Talisman 3rd edition

The dragon's tower is super awesome! ...and also super rare and expensive today.

Here is one you can print! I found nice high-res art here and scaled it / printed it / glued it to the model.

This version is just slightly larger than the original, because I wanted it to neatly fill the center of the board.

You need to print one of each floor, two of each tower section, and one of each wall.
Once printed and the art is glued, put the four 'tower' pieces together and lock them into Floor 1.
Floors 2 and 3 should drop nicely on top. You may need to file or sand the floors to make them land at just the right spot.
Then add the wall pieces and bob's yr uncle.

I also included a base for whatever beastie you wanna put up there, or you can just use it as a tower cap.