Summary

Small box to hold 2 x 1.5 volt button batteries, LR1130 or AG-10 for powering a LED globe.

Instructions

Cut a paper clip into 2 parts as shown.
Push the smaller one right through the bottom of the box.
Put 2 x button batteries in negative down and then opush the U shaped paper clip through the two top holes to the far side to hold the batteries in and make the positive contact.
If you don't get a good contact depending on your printer settings, fold up a small piece of aluminium foil and place under the batteries.
Solder to your globe or connect with buldog clips.

Miniature Battery Box