Summary

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/9FeyJk8loUf

It's designed to be used with the WiiChuck I2C breakout board, which is sleek little tongue that should just fit into the hole down the middle.

Print Settings

Rafts:

Doesn't Matter

                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>50%</p></div></p>                                                    <strong>Filament:</strong> Generic TPU                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>This is designed for use with thermoplastic urethane (TPU), but may work with PLA.  You need supports, but for TPU, try to have at least two layers (0.4mm) z-gap; TPU is <em>very</em> sticky.  If you don't have enough of a gap, you'll never be able to get the scuzz out of the hole.</p><p>Print with the face pointing down.</p></div>

Nunchuck / Wii Pro Controller / (S)NES Classic controller port housing