Printrbot Simple Tower ziptie board enclosure

If you're like me you thought the board was just a little too close to the moving parts and also impossible to access the micro sd card slot! I had problems with ribbing caused by the Z axis clamp hitting cables constantly, this helped!

I had cut open the side of the Simple Tower add on, but if you don't have the tower, anything before where the board was mounted to under the machine should be just fine with this. The slots on the case are to secure the case with zipties at their normal points on these machines (2013, 1401, early/modded/upgraded 1405). but this could probably be used to mount it most anywhere with zipties. You can print with support to catch the overhangs but I didn't need to, turning the fan on a little before it got to that part was just fine.

Made a deeper version to clear some of the connectors, especially the power connector.

The cutout of the logo isn't exactly over the silkscreen. I'm not sure if this is because of my slicing or something else.