Summary

Just my headset stand.

Total height: ~24.5 cm

Printed in 2 parts. The top and the bottom one. After Print just glue them together at the notch. Or maybe it holds just as printed.
I designet a offset of 0,75mm to each side of the notch.

If you print this i would like to see a make here :)
If you have any questions just ask them in the comment section.

Print Settings

Printer:

Geeetech A10M

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>15%+</p></div></p>                                                    <strong>Filament:</strong> noname PLA                doesnt matter

Headset desk stand