Addition to the design "Magnetic Gunstock for Quest/Rift S"

This is an addition to https://www.thingiverse.com/sanlaki magnetic gunstock for oculus quest/rift s

It's made to fit 32mm europeen standard pipes

inside gunstock support magnet.stl - Goes inside tube to prevent collaps of pipe if using a bolt rather than a screw.

magnet shim 5mmx30d.stl - Is to shim up a 1mm steel plate instead of using an additional magnet on the grips

The inside support is usefull to make sure You get drilled through the center of the pipe.
Drill a 4mm hole on one side, insert the support to line up, then drill 4mm through the lined up hole through the wall of the pipe on the opposite side of the pipe.

I use a 3mm x 40mm hex head bolt