Summary

A desk top tripod for use with a web CAM, small camera or what have you.

Instructions

Material: ABS PLA HIPS your choice
Raft & supports OFF
infill 35%
After printing, install the legs into the base with the build plate side of the legs facing out, legs should be flush with the outer edge the base.They will be a tight fit.
Drill the hole out with a 2mm or 5/64" bit.
Using a soldering iron, mushroom one end of a 20mm to 22mm long piece of 1.75mm filament. Insert the clean end into the hole all the way then mushroom the clean end to fix in place.
Or use a 2-56 screw of appropriate length.
A small CAM should not require a leg tether, heavier items may require support tether to keep the legs from splaying.(works best at about 2/3rds from the bottom of the legs).
Most camera mounts are 1/4-20, the base will accept an Allen head cap screw

Desk top Tripod