Endcap for 45x45 aluminium profile with 10b groove screw in place

Endcap for 45x45 aluminium profile with 10b groove screw in place is a endcap.
This one wont come loose over time and won't come flying even if you give it a smack with a hammer.

1. Preperation:
   -Cut a m12x1,75 thred in your profile

2. Printing:
   -Outwards facing side to the prindbed.
   -NO SUPPORTS
   -1,5h printing time for screw and cap.

3.Post processing:
-Yust remove the island on the cap and you are good to go.

The hole in the screw does not need to be cleaned, it only prevents ovrepreasure on the inside of the profile.