Summary

Remix of BillyAnt's nice design. I added a bracket to the right support to hold the X carriage wire harness.

Instructions

Stick to the printer sides with 3M Double Sided Foam Tape (1/16" or 1.6mm thick). This tape is available at most hardware and stationery stores. You may need to lightly file the rod holes. To fit them I placed them on the rods with out the tape, marked the bottom corners of the stabilizers with a marker, then removed the printer cover and taped them. If you aligned them properly they should slip right onto the rods with a tight fit when you put the cover back on. I put Micky Mouse ears on the right one because I had warping problems when printing with ABS. These can be trimmed off. They would probably be fine in PLA because the top of the printer does not get that hot.

Robo3D Printer Z Axis Rod Support