Summary

The frost really came this morning, and my "new" Golf wasnt equipped with an Ice Scraper, so I had to make one :)
This is my Ice Scraper made to look like the Swedish flag.
It can easily be printed as either the Finnish or Danish flag as well.
And some other countries.
I might make a Norwegian flag if some one wants it.

This project was made possible by www.protech.se

Instructions

Remember that if you print this in solid model interior the model design is prone to warping.
Theres really no way to get around this on a MakerBot to my knowlage. You could try to print with a higher temp if you have problems with warping.
The 2X would want a higher temp on the build table.
If your using Insight, a good way to print it is to use more contours, found under custom groups, and sparse high densety interior.
In insight and catalyst the pause can be inserted during the slizing and the printer will pause automaticly, remember it will pause before it starts with the layer containing the pause.
In Makerbot Desktop you currently need to manually pause during the print. This is different on each machine so figure it out first.
The part must be printed as is, laying on it's back to get "multi colour", since the design must be paused in Z.

Ice Scraper Flag (No Support)