DEEMS Device Accessories

1 vertical & 2 horizontal stands (vase mode)
4 holders for 30mm crystal pyramids (NOT vase mode)
a tray to hold the crystals & holders (vase mode)

The vertical stand has a .03mm gap on the side to allow it to print inner & outer surfaces in vase mode.

There are 2 edge holders & 2 corner holders for the crystals. They easily lock into the hole on the ring magnet.

The crystals pictured were "1.2 inches" or "30mm" on ETSY. (30mm = 1.181 inch). In actual size, they vary from 1.170-1.190 inch or 30mm ±.25mm. The edge holders are 30.5 & 31.0mm. The corner holders are 30.0 & 30.2mm.

The tray holds 10 crystals & 4 holders. I rotated it 45 degrees to fit it on my 140x140mm build plate.

print settings

stand h1, stand h2, stand v1, & tray all have mostly the same settings

VASE MODE
.25mm layers
.8mm line width & wall thickness (with a .4mm nozzle)
1.5mm bottom thickness, 6 layers @ .25mm (except Stand h1)

stand h1 has ZERO bottom thickness
BRIM on stand h1 & stand h2

-

holders

NOT vase mode
.2mm layers
.4mm line width
1.2mm wall thickness
100% infill
support from build plate
BRIM & maybe a support brim too

made with Tinkercad & Love

9-23-22
OOPS!
replaced .STL file for the Tray. it had a flaw i forgot to fix