Openbeam holder Bracket for Full Graphic Smart Controller

Holds the FGSC in place. Meant for 1515 Openbeam extrusions on the bottom of a Kossel Mini. Affix the controller board with four M3 screws and washers, and if necessary, nuts.

Uses the same clip as the wire fasteners I posted earlier.

I know, it's VERY hard to push them in because of the long clips, but once they're on, they stay on.

OPENBEAM_FGSC_holder.stl first iteration
OPENBEAM_FGSC_holder 2.stl second iteration; elongated and screw posts added