Summary

This is a camera plate for a Velbon CX580 Tripod which is about 15 years old and the plates are near impossible to get. You'll need a 1/4" mounting screw which you can pickup easily. 20% infill is probably strong enough but i'd print at 80 or 100 as its just a small but important part. PLA works fine. Mine printed on an Ender 3. Hope its useful to some.

Turn upside down to print, so that top of plate is on the bed. Then you won't need any supports etc.

Print Settings

Printer Brand:

Creality

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Ender 3</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>80</p></div></p>                                                    <strong>Filament:</strong> Any PLA                Black                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Print upside down so that the top of the plate is face down on the printer bed. Print at 80% infill for maximum strength. You'll need a 1/4" screw to secure to camera/scope etc.</p></div>

Velbon CX580 Tripod Camera Plate