Summary

This Pan and Tilt will fit into the cockpit of the Durafly P51D.
You will need:
Two 9g servos
One Cross arm
One single arm
Four servo mounting screws
spy cam

Instructions

this is a simple build and print in PLA

the camera is a spy camera from EBAY
To Assemble:
Glue the cross servo arm to the Lower Mount so you can still screw the servo arm to the servo

to mount:
-First work out where in the cockpit floor you wish to put the Pan servo.
-secure the Lower Mount to the Pan servo with the required screw.
-insert the camera mount into the Upper Mount and secure with bolt and nut ( I used ones from a Helicopter blade holder )
-connect the tilt servo arm to the camera mount with a push rod (again from a 450 helicopter rotor head)
-center the tilt servo then attach the servo arm.

fit the tilt servo into the Lower mount, then secure the Upper Mount with the servo mounting screws.
test movement does not bind by using a servo tester or connect to your RC equipment
insert the spy camera and wire to you VTx

link to youtube of it mounted in the mustang
http://youtu.be/tsLCf2J7AWg

Pan and Tilt for Durafly P51D