Summary

Small closing box for your medication.

Instructions

This is a small box with a hinge that uses a small paperclip to hold
both halves together. You can personalize it by printing your name
or logo and superglue it to the top. The two small magnets hold
it together. The magnets are 2mm x 4mm with superglue to hold
them in the holes. No support is needed and I printed this with 20% fill at 3m with a thick shell. It was about a 1.5 hour print.

Update: 3/20/15

I added Rev2 and Rev3 in the STL file Rev2 made the magnet hole a little deeper to hold the magnet more flush to the side.

Rev3 I made the hinge bigger and will hold a large paperclip it is
easier to put the paperclip though the hole just cut the ends when
its all done. Because the hinge is bigger I used a support for this
one.

Pill Box