Sliding Cover for Spigen Optik Armor (Samsung Galaxy S23)

Since I didn't want to open the cover every time I wanted to use the flashlight, I constructed a compatible sliding cover.

To avoid accumulation of dust, however, I did not want a hole at the location of the flashlight.
The flashlight is covered with 0.3mm material, if printed in white it will shine through without any problems.

I have uploaded two variants:

SM: print from a single bright material
MM: print of the window from one bright material and the rest from another material
The MM variant has a slightly different design because an area of 25x25mm was reserved for a QR code.

The 1st layer was printed from 100% perimeters only for optical reasons.

The part has very tight tolerances and requires good printer calibration.
The support material required different settings from the original Prusa profiles, see 3MF file.