MSI Katana M2 SSD Railing

MSI Katana notebook series has a common problem - there is a second m2 slot on the motherboard, but there is no way to screw the ssd, since railing is missing.
Issue can be resolved by asking support to send you one.

However, I was upset that there are no models of railing itself in the internet.
So I've measured and modeled the one MSI sent me.

This is precise model of mentioned railing.
If you are going to print it - please use ABS or other heat resistant plactic, it can be hot inside a laptop.

MSI_Katana_SSD_Railing_EasyPrint_V2.stl - use this one for printing, most likely there should be no problems. Thickened the base to 1mm, and wall to 0.8mm

MSI_Katana_SSD_Railing.stl - Precise model of original railing. Not for printing, it's a reference model made of the original metal railing.

You'll also need:
2x - M2x3 screws
1x - M2x5 screw for ssd, but M2x3 may also be ok for it