120mm fan mount 3 Bay 5.25"

Just a simple remix.

1 Removed fan Grille.

2 Trimmed sides by ~.5mm or so (it sits in a little, needed clearance.)

3 Added reinforcement. (2.5 of my tabs broke off just from handling.)

4 Edit: the holes are the wrong size, I used M4 hot press inserts or standard M3 nuts and heat pressed them in. Wrong: sized the holes for M3 hot press insert(I used 5.2mm, way too big). Could use nuts and bolts or Zip Ties as well.

︵‿︵‿୨ ✿ ୧‿︵‿︵✦︵‿︵‿୨✎୧‿︵‿︵✦︵‿︵‿୨ ✿ ୧‿︵‿︵

Possible improvements:

1 Add the second set of holes in the top and bottom bay.

2 Switch to attachable* "arms", will be much stronger if it prints flat.

• Either countersunk face screws, more inserts threaded in from the back or some kind of joint, tongue and groove?)

Enjoy. Many thanks to the creator.