Simon Petrikov glasses

Print two temples and a single frame, no supports needed. You may have some troubles printing the joint of the temples, but from 4 I printed out, only 1 turned out wrong. After printing, just snap them in place (make sure you make both ends face the same direction).

The frame has a tiny notch inside to put in some transparent plastic as glass. You'll need to cut a couple of circles of ~31mm in diameter.

Notes:
The glasses may be a bit wobbly due to clearances. Also, I had to curve the temples' ends for them to fit better behind my ears, but you can do that easily with some hair dryer. I found it better than trying to print them curved and have a nasty finish due to supports, but you may also try that if you want (Fusion 360 file attached).
Hope you like it. Cheers :)